Marketingový popis

S tímto 1000BaseT PCI adaptérem můžete vaše pracoviště připojit k gigabitové síti a využívat šířku pásma až 2000 Mbit v režimu Full Duplex. To znamená spolehlivější přenos časově kritických dat a optimalizaci připojení na síť a server. DGE-528T se připojuje přes metalickou kabeláž (Cat. 5e), odpadají tedy náklady na dražší kabeláž z optických vláken.

Klíčové vlastnosti

• Copper gigabit connection for PC
• 32-bit 33/66MHz clock speed PCI bus master operation
• Built-in 72K FIFO buffer to reduce overhead of memory transfers
• 802.3x flow control, auto MDI/MDIX support
• Supports ACPI 2.0 WOL power management
• Supports 802.1Q VLAN tagging, 802.1p priority queues
• Supports up to 7Kbytes jumbo frames
• Cable diagnostics utility provided
• Very small size, very low power consumption

Funkce produktu

• High-performance gigabit speed
  Capable of running at full-duplex gigabit speed, this card gives your PC 2000Mbps data transmission on your existing Cat. 5 twisted-pair network cable. As an inexpensive alternative solution to fiber-optic, the card allows you to instantly upgrade to Gigabit without requiring you to install new, expensive fiber cables. The card supports 10/100/1000Mbps network speed auto-sensing and full/half duplex auto-negotiation.
• VLAN to improve performance and security
  The card provides on-board screening of VLANs Tagged Ethernet frames, allowing your PC to be configured with a VLAN-supported switch. Your PC can be part of a VLAN network, where domains are segmented up to enhance performance and security.
• Wake-On-LAN for power management
  Wake-On-LAN (WOL) is an Advanced Configuration Power Interface (ACPI) function allowing a powered OFF computer to be powered ON from a remote station. This function allows the administrator to send wake-up signals to a computer. The WOL function provides a great utility for power management of the PC and allows users to initiate action at irregular times and from distant locations.
• Flow control to minimize packet loss
  The card's embedded flow control and independent FIFO provide a means to protect against possible data loss during transmission on the network. When connected to a gigabit switch supporting flow control, the card receives signals from the switch regarding buffer overrun during peak usage periods. The card then delays transmission until the switch is ready again to accept new data.
• Small form factor, lower power requirement
  Using a single chip solution, this card is very small in size and consumes very little power of your computer system.